Our range of Load Indicators are controlled by microcontroller that is highly adaptable for weighing / batching applications. To control drive, solenoid and material in hopper various controlling options are available. To cover wide spectrum of applications load cell / weigh bridge interface is offered. Other options like printer interface / PC interface / 4-20 mA output has been made available for versatile connect to PC or SCADA software or feed values to PLC.
- Four / Five digit LED display for parameter indication
- Micro controller based Digital Circuitry
- For set point optional 4 digit display is given
- For programming dust proof membrane keypad is used
- Load Cell Input interface for load cell.
- On site software calibration apart from Hardware calibration possible.
- Optional 4-20 mA retransmission facility for load
- NV RAM storage facility is given to retain set point in case of power failure.
- For drive control in batching applications, optional control output send outputs rated 230V / 5A (resistive). Provision for inflation correction.
- High Low relay alarm outputs optional.
- For PC or Serial Printer RS 232 serial interface is given
- Resolution: 12 bit / 20000 readings
- Calibration: Hardware and software
- Input Direct from Load Cell upto 3mV / V
- Output: Relays rated 230 V / 5 A
- Options: RS232 serial printer RS485 / RS232 Modbus interface Provision to connect upto 4 load cells.