FOB Price : Get Price
AUTOMAT has designed and manufactured Motorised lubrication Units for centralised automatic lubrication. These are electrically driven motor pumps containing reservoir, oil filler, suction strainer, bleed valve, pressure gauge, pressure relief valve etc. They are available both in MS and imported acrylic body.
Operational Theory :-
During On time of the motor which is normally 5 seconds meterd amount of oil is ejected from all the metering cartridges to lubricate the lubrication points. These metering cartridges are again recharged during OFF time of the motor. The outlet port of the pump is normally Ml 0 X 1. Additionally Pressure Switch and Float switch is applied to control over the oil presence and pressure, A Lubrication timer / Controller is also used to get the oil on required intermittent basis. An oil indicator is used to visualise the minimum oil level. Automat has added the Provision of Return Line Filtration with some models to reconsume access oil after it get filtered.
Distribution of Oil
Normally a main 6 mm line from pump to manifolds is send on which required metering cartridges are fixed. Additionally a secondary line is arranged with 4mm tube is applied to connect all the lubrication points.
We must always use oil with proper viscosity range which is 50-150 cSt for Transparent acrylic units and 50-1000 cSt for MS body. We should be regularly careful with the power connection to avoid motor burnt. Additionally we should fill oil before going its level below the 'Minimum Oil Level' position to avoid entering of air in the unit.
|MODEL||Reservoir Cap.||Pump Discharge||Motor||Relife Valve (per set at)||Pressure Switch||Float Switch|
|AMLU-2500-C||2.5 Ltrs. Transparent||0.75LPM||.12KW, 415V AC, 3Phase, 1440 RPM||15Kg/cm2||220V, 1Amp. with 1 NO+1NC Contact, preset at 12Kg/cm2||220V, 1Amp. With 1 NO or 1NC contact|