The CAMPISA Minilinker Ramp is a complete connection system recommended when the height of the vehicle truck bed is almost the same of the one of the dock (max +/- 100 mm from the dock floor).
Moreover is recommended for fleets of vehicles with homogeneous truck bed height.
Easy and quick to install either in the pit or to the rim of the dock, it is mechanically or hydraulically operated by just one operator. In case of manual operating for its connecting to the truck bed it is sufficient to insert a lever to lift the ramp that lifts assisted by a gas cylinder, the lip opens automatically by this manoeuvre and lays over the truck bed.
While loading and unloading the goods it "works" in its neutral position smoothly, following the up and down of the vehicle.
At the end of the loading operations, always assisted by the lever, the ramp is lifted and the lip folds back within this manoeuvre. Once the lip is folded back the ramp is descended in its rest position on its supports.
In case of hydraulic motorized manoeuvring this is performed by hydraulic cylinders controlled through a 1 button electric command box that operates all connecting operations and those of back to the rest position.
Deck anti slippery almond steel sheet, thickness 4+2 mm
Lip anti slippery almond steel sheet, thickness 10+2 mm
Dimensions total length 700 mm. Lip length 300 mm
Weight 210 kg
Concentrated capacity (as per the EN 1398) 4000 kg
Finishing Ramp and Bumpers supports, over painted in grey simil RAL 7005 colour. Lip, orange colour simil RAL 2000
Installation at the dock rim or inside the pit
Operating: Manual by the lever, assisted by a gas spring to stay within the limits of effort set by the EN 1398 or Motorized electromechanic by electric command positioned on a wall mount command box. The 400V 50 Hz three phased electrohydraulic powerpack can be positioned below the ramp
Max inclination +/- 100 mm (the EN 1398 Standard fixes a maximum inclination of the 12,5%)
MEGA type bumpers:
installation at the dock rim 250 x 110 x 450 (large x depth x height).They are installed on a steel boxed support 250 x 430 x 450 mm, total depth 540 mm
installation inside the pit 250 x 500 x 450 (large x depth x height). They protrude 110 mm from the dock
Side feet guards as requested by the EN 1398
Mechanic stop the deck (lip excluded) is equipped with mechanical limit switch which limits the negative excursion
Front protection plate in hot deep galvanized steel to be mount on the MEGA type bumper for the protection of its surface