A series of intermediate to heavy duty linings (or coatings) which can be applied to steel and offer long term protection against corrosion and physical abuse.These systems consist of a toweled applied base coat over a primer coat and followed by glass filled top coats to achieve excellent chemical resistance, exceptionally low permeation and high physical properties for over all performance of lining & coating. Each of the Mipro Glass 201 linings is reinforced with glass flakes up to 0.4mm (1/64 in maximum Dimension by 3-4 microns thick, which lie parallel to the substrate thereby offering ex-resistance to permeation, corrosion, abrasion, physical abuse and thermal shock. Mipro glass 201 series coatings will withstand total immersion at temperatures up to 70 C, a temperatures up to 150 C.The recommended thickness of the mipro glass 201 linings is 1mm to 3mm and this is two or more coats by trowel application. Plus Top coat by brush, roller or air less spray.
matt/cloth reinforcement is also possible for higher strength.
Mipro glass 201 series linings are formulated from different high performance resins:
- MIPROGLASS 201 - I Isophthalic polyester
- MIPROGLASS 201 - B Bisphenol polyester
- MIPROGLASS 201 - V Vinyl ester
- MIPROGLASS 201 - SV Vinyl ester – superior grade
- MIPROGLASS 201 - E Epoxy
- MIPROGLASS 201 - E (HYB) Hyb. Epoxy
|COMPONENT||QTY. REQUIRED PER SQ. MET.|
|MIPROGLASS PRIMER VE OR E||Approx. 0.250 to 350. KG.|
|MIPROGLASS 201 SCREED TROWEL APPLIED |
I.B.V.SV. E OR E (HYB)
|Approx. 2.2 kg. Per 1mm Thickness|
|TOP COATS Approx. 0.500 Kg (Two Coats)|
Please request Surface Preparation and Installation Data sheets for specific advice.
Cure times will vary with ambient temperatures and quantity of catalyst used. Typically the Mipro glass 201 series can be over coated within 4 to 6 hours and are hard in 8 to 12 hours. The coating will not be fully cured until about 72 hours after application but can go into light duty service after 24 hours.