We offer model 800AH programmable amp-hour meter, that is used for electroplating thickness control and testing battery Amp-Hr. These meters are available with 6 RED 7 Segment LEDs of 0.56” character height. However, the current display is fixed at Max 9999 Amps using a shunt of current & 75mV for user programmed. Following are some of the features of our model 800AH programmable amp-hour meter:
Settable Limit for
switches for easy operation
for storing settings, hence no battery required
Further, our Model 800AH Programmable Amp-Hour Meter has below mentioned technical specifications:
Amp-Hour: Max 9999
A-H for each preset cycle. (Amp-Hour range is selected by shorting
Pin 17-18 at the rear)
Amp-Minute: Max 9999
A-Min for each preset cycle. (Amp-Minute is selected, opening the
link between Pin 17 & 18).
Max shunt: Max value
of 9999 Amp corresponding to 75mV
Totalize: 6 Digits
for Amp-Hour or Amp-Min. i.e. 99, 99, 99. (readable for 10 sec by
going into ‘total’ mode)
Limit: Up to 9999 AH
or Amin. Setting (In limit mode using incr. & decr. switches).
Relay Contact: One
NO-P-NC of 5 Amp rating.
Trigger start: By
pressing front panel switch or closing a rear external contact.
Battery Back-Up: Not
required. Programmed values & readings, including A-H stored in
lock for calibration (open link between Pin 1 & 2 to lock CAL)
Trigger: Set at
10.5V internally, for testing 12V Battery AH. (With Pin 3 & 4
0.1AH or 0.1AMin facility by shifting internal jumper
Supply: 220V AC 10%
Size: Front Fascia
96 mm x 96 mm, Depth 135 mm, Cut Out: 91 mm x 91 mm.
Weight: 800 grams