This machine is suited to manufacture wood pieces
below 420 mm (length) and 130mm(diameter)
‧The rough pattern knife seat of this machine is manual
operation., but there are hydraulic drivers for holding
material and finishing knife seat.
‧There is one U-shaped knife for the roughing pattern
knife seat of this machine. You can do the reciprocating
cutting beside pattern many times by manual operation.
‧You can adjust height of the finishing knife seat.
‧There is a central needle for wood pieces to find the
central point and let it become convenient for holding.
‧The main spindle power is 3HP, the pump power is
1HP for oil tank's is 50L capacity.
‧The rate for breaking down is very low for this machine
because it is manual and hydraulic operation.