We offer Connectors and Cables. Mold Power and Thermocouple Cables more specifically designed for the plastic industry by process of hot runner injection molding, Dydac manufactures mold power and mold thermocouple cables designed specifically for your mold and temperature controller connections. Working hand-in-hand with processors as well as mold makers, Dydac can provide virtually any configuration or adaptor cable that is best suited for your individual process. Dydac can assist with cable design, cable and connector selections. With our just-in-time manufacturing capabilities, Dydac can produce cables on demand. Mold power cables are used to connect the mainframe to the power input connector located on the mold. All cables are wired for 5, 8, or 12 (rated @ 15A) zones as well as units working on 30A. Mold power cables are available in any length, 10 and 20 feet are standard stocked cables.
No. of Zones 10 Feet Cable 20 Feet Cable:
- 5 PC5Z-10 PC5Z-20
- 8 PC8Z-10 PC8Z-20
- 12 PC12Z-10 PC12Z-20
Mold Thermocouple Cables:
- Mold thermocouple cables are used to connect the mainframe to the thermocouple connector on the mold. Cables are wired for 5, 8, or 12.
- In most cases the connections on the controller remain constant, while the connector on the mold end can vary.
- Mold thermocouple cables are available in any length, 10 and 20 feet are standard stocked cables
No. of Zones 10 Feet Cable20 Feet Cable:
- 5 TC5Z- tC5Z-20
- 8 TC8Z- 10 tC8Z-20
- 12 TPC12Z-10 tC12Z-20