Our range of automatic rinsing machines, automatic filling machines, automatic capping machines, are high in demand in various sectors and are mainly used for mineral water/ Non-carbonated beverages. The entire procedure has requirements in the filling machine for rinsing, filling, capping and sealing automatically and process is fully computerized with PLC and sensor Control with one touch instrumentation. Capable of bottling various sizes of bottles ranging from 500 ml to 2 Ltrs, the mineral water / bottles are fed into the input feed conveyor.
- Bottled Water
- Light Sauces
- Edible Oils
- Specialty Chemicals
- Cleaning Chemicals
- Corrosive Products
Different procedures are mentioned below:
The bottles are mechanically picked by the rinsing rotor, using spring loaded grippers. Bottles are reversed automatically to start the rinsing cycle which in most cases used product water as the rinse medium. Mechanical rinse valve provides the feature no bottle-no rinse, which safeguards against wastage of treated water. At the end of the rinsing cycle, the bottle is worn out of most remaining water, before being straightened out and handed over to the filling rotor.
This system fills every bottle to the preferred volume adopting the vent pipe filling principle for accurate filling. The mechanical spring loaded filling valves are actuated automatically by the bottles when lifted up to commence filling. In this stage again the bottles are held at the neck by neck holding lifters and the machine operating speed can vary using variable speed AC drive.
The bottles are held at the neck decisively during capping to fabricate completely leak proof results. Caps are feed into the machine by an automatic cap elevator with an SS 304 ground level hopper which can contain up to two thousand caps. The cap elevator feed caps at the desired rates to the cap pickup rotor of the machine.