Welcome to HelloTrade!
I Want to Buy
Request for Quote

Solvent Recovery Equipments

Next Product »
FOB Price : Get Price

To meet the diversified requirements of our prestigious clients, we are engaged in offering Solvent Recovery Equipments. The specialty of the equipment is that the machine can remove the solvent from the chemicals. In addition, the machine can produce the volume quantity of 80L. It takes just few minutes of the unit to recover the solvent from the bulk. Moreover, the equipment is loaded with computerized controlling and micro processing sensors aids in measuring the accurate pressure and distillation of the solvent in the substance.
Features:

  • Recovers 80% of solvent
  • Recover time is 6 to 7 hours
  • Volume is 80L


A. General description:

This is designed for recovery of flexographic photopolymer plate solvent washout chemical and any environmental green chemical with specialties of distilling and cooling, can be connected with in-line processor and any plate washout machine directly. With cold air circulation and drain out of residue for high speed recovery. Super recovering rate in the shortest time, is an ideal and high efficient recovery unit for flexographer.

B. Technical information:

Recovery volume : 60 / 80 liters
Power consume: 220V 4.65KW
Diathermic oil : 23 KG
Machine dimension: Main body: 1100x 780x1200 mm
Recovery rate: 85%
Recovery time : 3 ~ 4 hours

C. Operating steps:

1. After opening the crate, plug in 220 V power, and connect the ground (earth).
2. Open the lid and fill the tank up to the level with solvent to be recovered (80 L)
3. Close the lid and tighten it.
4. Check all the pipe / hose make sure it is well connected. Especially vacuum pipe (6) and fresh come-out pipe(1).
5. Set up the thermostat(18) for example for Perc.is 150 degree C, for green chemical is 160-210 degree C. Vacuum tank pressure(3) high at 0.03 Mpa / low at 6.01Mpa, and steam cooling fan thermostat(11) at 40 degree C.
6. Turn on the power switch(15), steam cooling switch(16), heater switch(17) and vacuum pump switch(12).
7. If you want to be controlled with timer, it depends on the quantity of the chemical, set up the timer(14) then turn on the switch(13).

D. Important:

1. Install the unit in a wide and ventilated place.
2. Disconnect electric power before doing any action.
3. No taking off the control panel
4. Change the diathermic oil every 1000 working hours.
5. No filling the solvent container up over the level (80 liters)
6. Remove the waste after every recovery process

RELATED PRODUCTS
 
X

Invalid Input
Please enter Mobile Number
Invalid Email ID
Invalid Email ID
Your Contact Information
Convenient
Competitive Quotes
Choice of Suppliers
Payment Protection
 
sending enquiry ....

unable to instantiate your call right now. please try after some time.

close

©Copyright HelloTrade.com