Minvalco Incorporated

The No. 200P Poly Sprayer is constructed of high density translucent polyethylene. It has a 2-gallon working capacity, funnel top, pump handle and is equipped with all brass hardware. No pumping is required.....pressurize sprayer with water. Packaging Description Size Part # No. 200P Poly Sprayer 1 Each 4771-2 Product Literature Downloads: No. 200P Poly Sprayer - Instruction Bulletin

The No. 220CP Poly Sprayer is constructed of high-density polyethylene. It has a funnel top which provides for easy chemical pouring and has a 2-1/2 gallon capacity (2 gallon working capacity). It comes with a 10" polypropylene pump, handle, 12" tube with adjustable nozzle and 3 ft. hose. The No. 220CP Poly Sprayer can be used for spraying solutions of CalClean, Special HD CalClean, Alka-brite, Nu-Brite, Coil Pow'r, Evap Pow'r-C, Cal-Brite, and Cal-Shield on air conditioning cooling coils, air-cooled condensers, finned heating coils, refrigeration case or cooler coils, permanent air filters and other greasy, dirty surfaces. Operation Inspect sprayer, and insure the hose is securely attached to the tank and to the shut-off handle. Remove the pump from the tank by turning counter clockwise. To minimize foaming when preparing a cleaning solution, add water to the tank before adding the cleaning solution. Fill Tank to fill line on side of tank. Close tank by inserting pump assembly through opening. Turn cap right (clockwise) until pump is sealed tightly into the tank (hand-tighten only). Pump plunger to compress air and create pressure in tank. Twenty strokes of plunger provides a good working pressure. As pressure drops during use, recharge with 20 or more pump strokes. More strokes will be needed if the tank is not full, or as the sprayer is used and the pressure drops. The nozzle tip may be adjusted to provide a single-needle stream (tip screwed all the way out) or a fine mist (tip screwed all the way in). Spraying time will vary from about 5 minutes with the needle spray to about 12-15 minutes with the fine mist. The needle spray should be used on finned coils to reach the third and fourth banks better. The mist is better for cleaning permanent filters. Allow the cleaning solution to remain in contact with the dirty surface for about 15 minutes, then flush with water from a hose. If a hose is not available, fill the sprayer with water and flush using a course spray

The No. 300P Poly Sprayer is constructed of high density polyethylene. It has a funnel-top which provides for easy chemical pouring and has a 3 1/2 gallon capacity (3 gallon working capacity). It comes with a 10" Celcon pump, extension tube with adjustable nozzle and five feet of vinyl hose. Packaging Description Size Part # No. 300P Poly Sprayer 1 Each 4772-0 Product Literature Downloads: No. 300P Poly Sprayer - Instruction Bulletin

The No. 50P is constructed of high density polyethylene. It has a half gallon capacity (3 pint working capacity). The nozzle is adjustable and the flow rate is controlled by a thumb lever. It comes with a 7&qout; polyethylene pump. Packaging Description Size Part # No. 50P Poly Sprayer 1 Each 4770-0 Product Literature Downloads: No. 50P Poly Sprayer - Product Bulletin