The Hay elevators heavy duty ”1 x 1” square tubing structure dares to stand up to the toughest task. Many years of quality workmanship has made the Forage King hay ele vator your No. 1 choice. 1” sealed bearings on all shafts make it a low maintenance and durable piece of equipment
Square Bale Guides
This is a set of tubular guides mounted on the elevator to keep the square bales in line when transferring from inclined to horizontal elevators
MB4 Basic Drive
Heavy duty 5 ft. drive unit including a 12” end section.
all shafts are 1” in diameter on roller bearings;
use No.40 roller chain drive;
motor mount and No. 55 chain included
end section has threaded chain tightener
A Transfer Drive should be used in mow systems and conveyors over 80’ in length. Mount the transfer drive unit in the centre of conveyors which splits the long chain into two smaller lengths and that will result in longer chain life. Only one power source is required as the fully enclosed chain drive transmit power from one section to another. It can also be used to connect end transfer power from a horizontal to incline elevator ay any angle through tp 45º.
Center Sections Center sections will fit any Forage King Hay Elevator System and are available in 2, 4, 8, and 10’ lengths complete with No.55 conveyor chain.
Underslung Motor Mount
Recommended on horizontal elevators with a motor over ¾ HP. This position places the motor directly underneath to balance the system
MB4G Gearbox Basic Drive
Heavy duty 5 ft. drive unit including a 12” end section with a threaded chain tightener. The MB4G Gearbox features reduction gearbox eliminating pulleys, belt and roller chain. All shafts are 1” in diameter in roller bearings. No 55 chain included
Bales can be discharged anywhere on a mow system. Two holes on the Diverter (with 12” spacing) allows for more accurate paddle positioning when dropping big bales between trusses of your barn. The Diverter allows you to reverse with a reversible motor.
90º Turn This enables bales to make a 90º turn from one elevator to another. Diverter section must be used to attach this to the system. Makes filling a large barn a whole lot easier.
Slide Chain Lifter
The Slide Chain Lifter is designed to carry the return chain. Place as required
Position every 16 to 20’ to suspend system from the rafters
Folding chute attached to the intake elevator for easier unloading and placing of the bales on the elevator.
Bale Arranger To be used when unloading horizontal with transport elevator.
A special 4’ section with spring tensioned diverter arms for either-side unloading. They can be placed at regular intervals throughout the system. Raised trough lifts bales off the hooks for easier discharging. It is possible to use ropes to operate the diverter arms from ground level (ropes are not included). One slide chain lifter is included.