The 5-gallon (18.9L) water bottle is already common all across the USA in offices and factories. It is becoming increasingly common in Europe, and in areas such as Latin America, where tap water is undrinkable or non-existent, the 5-gallon bottle has found a market in domestic use. The potential for a 3-gallon domestic cooler is now being seriously examined, with the major water companies delivering direct to homes, bypassing supermarket distribution. The market is only waiting for one of the major domestic electrical equipment suppliers to take the first step.
The material used today for the 5-gallon bottle is overwhelmingly polycarbonate (PC). The material is, however, costly - much more so than PET, and hence only refillable bottles are produced. This also applies to PET bottles, which are currently produced principally on single stage machines outputting typically 100 bottles per hour. For the market to evolve at the desired rate for PET higher outputs will certainly be required.
- PET Preform for 5 Gallon PET bottle is 400mm long, and weighs 650~750g.
- Capacity: 25-30 pcs/hour.
For further information:
Please contact us.
* Pneumatic related (Low Pressure), FESTO/Germany;
* Pneumatic related (High Pressure), FESTO/Germany + SMC/Japan;
* Controller (with Touch LCD), Inverter, Mitsubishi/Japan;
* Contactor, Relay, Switch, Schneider/Germany;
* Circumstance Independent
NB5G runs stably, whether voltage is 200V or 240V, or whether room temperature is 00C or 400C.
* Easy Operation
Minimum parameter settings (through touch LCD), normally only temperature settings should be regulated, no need to play with time settings; Multi-language interfaces;
Completely new-concept design, more mechanical & synchronized design to reduce fault to minimum level.
Air recycling unit to save compressed air 20~25% (for 5 Gallon);
Reduced heating power;
Driving is mostly done by motor directly, instead of compressed air.
* Higher Output
200% more efficient than traditional one.
* Fast Mold Changeover
Adopts Aluminum mold, lighter to be installed or unloaded;
10 molding data memories to make mold changeover quicker.