slim rod pullers are used to convert polysilicon source rods of approx. 25-50 mm diameter into slim rods of approx. 7-10 mm diameter and lengths of up to 2500 mm.
this machine is very effective since two slim rods are produced at the same time, using a double hole hf-coil connected to one generator. Every care has been taken to make the machine very operator-friendly and to allow fast restart of pulling after harvest of the produced slimrods. The glow in the source rods is maintained during harvest. This is made possible through a special valve closing between the main and upper chamber during the process. One set of source rods will yield 12 to 50 slimrods depending on the diameter of the source rods and the length of the slim rods.
Coiled tubing BOP is available in bore sizes from 2 9/16" to 7 1/16" and working pressures from 5000 to 15,000 psi, with the following features: ...Cameron
Fully automatic key cutting machine for flat cylinder, car keys and cruciform keys. New type, double sided, revolving clamps with three positions for ...Silca
Found in 5-star hotels worldwide! This beautiful 18/8 stainless steel carafe features a hinged lid for easy pouring, triple wall insulation that ...Hormel Corporation
sending enquiry ....