Q-SET’s have a universal UL listing: For the first time ever a power supply receives not one but three listings: Landscape Lighting, Pool & Spa and Low Voltage Luminaire Power Supply (for both indoor and outdoor) lighting.
All Q-SET’s are powered by extremely efficient toroidal transformers manufactured to run at 95% + efficiently. This high efficiency conserves energy. No de-rating of the Q-SET is required as the model number indicates the total lamp load.
Available in traditional 12VAC or 24VAC from 60 Watts to 900 Watts, all transformers have multiple taps on the secondary side of the load to compensate for voltage drop and two taps on the primary for a system that is switched and a tap if connected to a dimming system.
LED Power supplies are available in both electronic and magnetic versions. Our SET-eLED (Electronic) is available in either 60 Watt or 120 Watt versions in 12VDC and 100 Watt and 200 Watt in 24VDC versions. You can fit two LED QSET’s inside the Q-VAULT-5.
The Magnetic version (QSET-mLED) is available from 60 Watt to 180 Watt in the 12VDC version and 100-300 Watt in the 24VDC
1. All 120V units have a hydraulic, magnetic, push/pull circuit breaker with a custom watertight bellows boot to allow switching the primary on/off.
2. The toroidal transformer has an internal auto-reset thermal breaker to disconnect the primary if there is an overload or improper dimmer.
3. Each Q-SET has 1, 2 or 3 secondary hydraulic, magnetic, push/pull circuit breakers with a custom watertight bellows boot to allow switching the secondary on/off.
There is a Separate Primary junction box for added safety. The JB cover has a strip length guide for the contractor, a pocket to hold water proof paper for field notes, a hole to allow re-setting the primary circuit breaker without removal of the cover, slots for wire ties to manage the field wiring and a locking device to hold the terminal block hex key. There are two ½” openings for field connections into the JB allowing for through-wiring if needed. Inside the JB there is an extra boost tap on the primary to offset voltage drop on long primary runs or when connected to a dimmer.
BUILT TO LAST
All terminal blocks are rated for 50 amps and made of nickel-plated, 70/30 brass with two - 316L Stainless Steel set screws. This large terminal block allows for a one inch strip to assure a positive connection. The capacity of each block is: 7 number 14AWG, 5 number 12AWG, 4 number 10AWG or 2 number 8AWG.
The secondary features five (5) output voltages available at all times. There is no limitation on the amperage allowed from each output; the full amperage of the Q-SET can come from one output.