Wire Recycling can often go hand in hand with a Tire Recycling Plant as a value added part of the system.
Grinding a tire to a small particle uses the same equipment to grind wire to a small particle for separation of the copper from the aluminum and the plastic.
As mentioned above the first stage of this process normally involves obtaining the proper permits required to have a recycling facility.....
Once this is accomplished, then you can proceed with purchase of your equipment, and the installation, and operation of the business.
To submit your permit application, you need to contact at the State level the proper coordinating agency that handles these permits.
There is always an Agency in charge of this task at the State Level that coordinated all Recycling efforts.
Most often than not, there is a dedicated Agency that handles all Recycling Programs, including but not limited to tires and wire, and other waste materials...
Sometimes, it is best to inform these Agencies at the State and Local levels that you are planning on operating a recycling facility, for wire and tires, but possibly for other types of materials...
We have found that a multi-function facility is desired more than a dedicated facility by these Agencies.
The problem in the past, with those groups who have been involved with tire recycling, is that many have failed.
This has put a bad taste in the mouth of the various Agencies who coordinate these programs. They get a lot of calls from dreamers, and they are tired of wasting their time.
In essence, they have been dealing with various groups who have not followed through properly, and they are very cautious with new groups who want to submit paperwork for a permitted facility.
As you may know, it can take millions of dollars of investment to implement a recycling facility, and that is why these types of facilities are not on every corner, like McDonalds...
If you do have the ability to implement this type of program, you will join into a very elite, and special group, who wish to perform a recycling function for society.
What we recommend, if possible, is a permit for a full Recycling Plant that can process a wide range of materials...
Our multi-function systems can process :
* Wire cable
* Wood Waste
* Electronic Scrap
And other materials...all in the same system if it is designed for that function...
So begin your task by reaching the State Agencies in charge of this process, and at the same time your Local Agencies, to see what they want and what they need to implement this process.
We have found that a full Recycling approach, may be better received than just a single type of application.
However, if this approach complicates the application process, then a single source application for just tire recycling is the direction you should take.
Today in a wire recycling plant you must be able to separate the copper from the aluminum and the plastic. Our systems perform this function on an automated basis. In the same plant, a tire recycling facility you must be able to make a wide range of products from tires, from a fuel chip to a wire free granule to a crumb rubber. Our system performs this function also.