• Microprocessor based conventional fire alarm control panel designed to
• EN54-2 & 4
• 4, 6, 8, 10, or 12 detection zones
• One man test facility
• Two sets of volt free changeover contacts operable on fire
...
• Modulation : FM, FSK, PWM
• Frequency : VHF 137 – 174 Mhz/ UHF 410 – 504 Mhz
• Output Power: 7W in VHF / 2W in UHF
• Output Impedance: 50 Ω BNC connector
• 8 dry contact inputs
• Programmable ...
• Two operational modes (addressable for the Digiplex EVO series or conventional relay operation)
• Remote test mode when used with TestTrek V2
• Full audio and infrasonic spectrum analysis
• 7 frequency digital filters, ...
The hochiki’s reflective beam detector is designed for smoke detection in large spaces such as halls, warehouses, museums, theatres etc. , where conventional point detection is impractical or more costly. The unit detects smoke linearly over ...
read moreThe mbf-6ev is a six inch diameter internal use conventional alarm bell based upon the industry standard kobell range. ordering codes: mbf-6ev operating voltage: 19. 2 – 28. 8 vdc rated current: 11ma 12ma operating temperature range: ...
read more acb-e is a multi-heat sensor, which is fully compatible with hochiki. S esp analogue addressable protocol.
the acb-e incorporates a variable temperature heat element and a rate of rise heat element, both of which are controlled from the control ...



sending
enquiry |