Lubomatic centralized dual line lubrication system basically consists of a reservoir with built in reciprocating plunger pumps immersed in the oil / grease change over valve, dose feeders (dual line metering elements) end of line pressure switch, pipes, hose pipes fittings, control panel etc. The discharge of oil / grease is alternately forced into the two main lines through the change-over valve. The valve is hydraulically / electrically operated. When the pump is switched on the line 1 is connected & the pressure goes on increasing and when it reaches set high pressure all the points are lubricated. As the valve moves forward the line gets blocked & the pressure goes on increasing and line changes to No.2 line, this goes on repeating. The dwell time is adjusted as per the requirement and after set dwell time the cycle goes on repeating.
The discharge of oil can be controlled by:
- Increasing or decreasing the pause time
- By the regulating screw fitted on the dose feeder indicating pin.
- Easy to operate and control
- Optimum performance
- Rolling mills
- Water pumps
- Cement Industry
- Sugar mills Industry
- Paper and forging plants