Member
Since
2
Yrs
Ventrex Inc.
3007 Bunsen Ave., Ventura, Ca 93003
Ventura, California-93003, USA
Next Product

Uv Cure Adhesive Dispensing System

The Ventrex model UV8350 BlackMAX dispenses UV cure adhesive onto cylindrical components by simply inserting the part into the applicator.

There's no foot switch, dispensing needles or syringes required. Just fill the reservoir with up to one full liter of UV adhesive, couple to line air and go! The UV8350BlackMAX can be easily integrated into a semi or fully automated production line.

The work area stays clean because the UV adhesive goes only where you want it... from the dispenser onto your parts. Unlike needle dispensing systems, there's no stringing or oozing of adhesive.

Maximum Repeatability
The UV8350 BlackMAX dispenses adhesive evenly onto the entire bond surface of the component. By "wetting" the entire surface, much more consistent and repeatable bonds can be achieved. Applicators are available for O.D. dispensing, I.D. dispensing and both simultaneously.

The porous materials contained in the applicator are specially selected for the viscosity of UV adhesive being applied. This assures the correct volume of UV adhesive is "held" on the transfer surface at all times. As your component is inserted into the applicator, this volume of adhesive is transferred to the part.

Send Enquiry
Your Contact Details

More Products From Ventrex Inc.





 
 
 
 
 
Recommended Product
 
 

sending enquiry
Thank You

unable to instantiate your call right now. please try after some time.

close

© Copyright HelloTrade.com
Home | About Us | Partner with us | Disclaimer | Testimonial | Feedback & Complaint | Help