VIRDI’S Electroplating Rectifier is an economical and most efficient method of obtaining D.C. from A.C. supply by anodizing and many other electro-chemical processes. The widest applications in the field of electro-plating normally requires maximum voltage of 8V, 12V, 16V and 20V D.C. at various current capacities as per requirement. A range of current rating from 50 to 5000 amps is covered in our regular range.(Other ranges available on specific order)
VIRDI'S RECTIFIER FOR RECTIFIER FOR :
- Cleaning & Other Electrochemical Processes
TECHNICAL SPECIFICATION :
|Input Voltage||380/440 Volts A. C. 3 phase 50-1500 Hz|
|Output Voltage||Fixed Rated Maximum D.C. Voltage or variable from zero to |
maximum rated voltage
|Output current||Rated maximum D.C. Current.|
|Efficiency||Not less than 98%|
|Temp. Rise||Less than 45o C ambient at the top of the oil.|
|Oil Grade||Special transformer oil.|
A.C. INPUT :
VIRDI'S Rectifier is designed for three phase 50 Hz A.C. input supply are suitable for operation at any voltage between 380/415 volts bread crumbs needs to be corrected
D.C. OUTPUT :
The D.C. output is variable in steps or continuously and steplessly variable from Zero to its rated full load. VIRDI’S rectifier comprises of the following controls for D.C. output:
VER-15 Steps Control (range variation from 40% to 100% D.C. output voltage).
VER-63 Steps Control (range variation from 15% to 100% D.C. output voltage).
VER-Stepless Control (range variation from 0% to 100% D.C. output voltage).
VER (S)- (Stepless control with transformer in separate tank).
The ripple content in the output is very low and is less than 5% and as such these units are very much suitable for all special processes such as chrome plating where low ripple content is necessary.
The circuit employed in VIRDI’S Rectifier is simple and universal. A.C. supply is given to an auto-transformer, which in turn supplies a variable voltage to the primary of a three phase double would Delta/Double star connected transformer. The secondary of the transformer is connected to hex a Phase/ Bridge connected rectified using silicon diodes. The output is obtained from the rectifier and the star points of the transformer through an inter phase transformer.
This is made up of sturdy liberally rated silicon diodes are connected in parallel. On a special made up of casting heat sink and depending upon the output rating of the rectifier units.
METER PANEL :
A moving coil ammeter and a moving iron voltmeter along with indication lamps are provided on a panel indicating the output current. The panel is mounted on one of the tanks to enable easy manipulation.