The In= Door Brush when fixed to the bottom edge of the front door V It keeps out dust and posts V It keeps out noise, odour and smoke V It will save energy by preventing cold air from escaping in a erticonditioned room 1/ It will prevent the WAI01 from splashing out especially from the bathroom
important• Do not remove the protective release paper until AF TER you have cut the uPVC holder according to the site of your door • It Is not necessary to use the pm% Sirpeked if yOu are fixing the Brush to the Door of your home • For those who prefer to screw clown the Brush. widen the pin holes to the Hs mired 0:0 With a drill
Fig 1. It the Door Brush is too long withdraw the nylon bruthstrip from the irPVC holder and cut on the excess length with the cutting section of a prior Fig 2. If a Mier is used to cut the brushstrip, some plastic of rubber adhesive glue must be applied to the ends where the cuts are made to prevent the nylon brush filament frum fraying (It Is better to use the phor to clip the end of the metal holder to prevent the wire from coming out ) Fig 3. If a line-tooth hacksaw Is used to cut the uPVC holder to the coned length, cut out equal amounts horn each end and slot back the nylon brushstrip Into the uPVC holder Make sum that the section of the door to which the Door Brush is to be fixed is CLEAN and DRY FIG •. When the Door Brush is of the correct iongth, remove the protective release paper on 'he Brush Close your door. rest the taushstrip on the floor with Brush at the bottom edge of the door Slowly press the Door Brush in place.