65-85 durometer solvent resistant blade, such as PU.
40 square meters per kilogram under 140T mesh.
This ink should be thinned with thinner approximately 10-20% by weight base on the climate condition.
A06 (extra slow dry), 202(medium dry)
783 (slow dry), 718/cycloheanone (medium dry) or 719 (fast dry).
When environment temperature is over 30or application on small printing area, slow and medium thinner should be selected. When environment temperature is below 20or application on large printing area, medium and fast thinner should be selected. Always mix well prior to each use.
Drying by solvent evaporation. Surface dry needs 20 minutes or more, complete dry allows at least 2 hour.
(Drying time depends on actual weather condition and thinner usage)
Force to dry with hot dryer below 100is allowed.
Matt promoter(2-10%), dilutor, flow promoter(1-2%), anti-smear additive(0.5-1%).
Adhesive tape test C use adhesive tape to stick on test surface and rip off, no ink should come off from test areas obviously.
Using organic solvent to clear the stencil.
PRODUCT RANGE AND PACKAGE
All of the colors are available in 1KG, 5KG and 20KG containers.
This ink is corrosive to PS.
This ink does not have alcohol resistance.
783 and A06 can provide better solvency.
Its the printers responsibility to pretest the ink selected prior to engaging in a production run. Allow at least 24 hours after test printing to evaluate the suitability of the ink and its adhesion to the surface. Before using, the printer shall determine the suitability of the product for its intended use.