Monofilament mesh, 60T-120T. 80T is recommended.
Using organic solvent resistant emulsions.
65-85 durometer solvent resistant blade, such as PU.
30 square meters per kilogram under 80T mesh.
This ink should be thinned with thinner approximately 10-30% by weight base on the climate condition.
783 (slow dry), 718/cycloheanone (medium dry) or 719 (fast dry).
When environment temperature is over 30or application on small printing area, slow and medium thinner should be selected. When environment temperature is below 20or application on large printing area, medium and fast thinner should be selected. Always mix well prior to each use.
Drying by solvent evaporation. Surface dry needs 7-15 minutes, complete dry allows at least 24 hours.
(Drying time depends on actual weather condition and thinner usage)
Force to dry with hot dryer below 100is allowed.
Matt promoter(2-10%), anti-oxidizer(2-3%), 9004(2-8%), 9005, flexible additive(0.5-0.8%).
Adhesive tape test C use adhesive tape to stick on test surface and rip off, no ink should come off from test areas obviously.
Using organic solvent to clear the stencil.
PRODUCT RANGE AND PACKAGE
All of the colors are available in 1KG, 5KG and 20KG containers.
If 9004 or 9005 was added, the printing process should be finished not more than 8 hours. The stencils and blades should be thoroughly cleaned before process breaking.
Mis-choice of the thinner may cause ink status damage.
Its the printers responsibility to pretest the ink selected prior to engaging in a production run. Allow at least 24 hours after test printing to evaluate the suitability of the ink and its adhesion to the surface. Before using, the printer shall determine the suitability of the product for its intended use.